Grab your Discounted Light Film Wrap 30X60CM while the Store LAUNCH DISCOUNT is on!

Have you ever seen some cars look as the same as yours? Now, here is a chance to make your car so special and gorgeous! You can choose the stickers color to decorate your car light . Wrap like a King with Discounted Light Film Wrap. This dual-layer film incorporates beautiful color and clear protective layers, providing a smooth, gloss paint-like finish. This enhanced film technology ensures excellent quality on deep recesses. Incorporating Easy Apply™ RS technology, Supreme Wrapping Film provides re position ability and slide ability, saving valuable installation time.

Features:

• Brand new and high quality
• Waterproof
• Smooth Surface
• Stretchable
• Self-Adhesive
• Easy Removal with No Residual
• Suitable for Any Headlights, Fog Lights, Side Marker lights or Even Top Part of the Windshield, etc.
• Size: approx. 30cm x 60cm / 12" x 24"
• Material: Vinyl
• Measure the size you need, then use the knife to cut.
• Choose the location to stick and clean with the wet towel.
• Spray water thin on the surface of light.
• Rip away the film and spray water on it.
• Blow dry with heat gun to remove bubbles.
• Use the tool again to strike off the bulb carefully as it will influence the eventually effect.
• Use a art knife to cut the rest film.

Details: 

• Made with an automotive-cast vinyl. Protects your paint from scratches and wear. Can be easily re-positioned and stretched for exact fitment and is soft enough to conform to all edges/contours/shapes. Creases and air bubbles can be removed by applying heat and using a squeegee.
• Will not harm painted surfaces. Can be easily re positioned during installation and does not leave adhesive residue behind
• This Vinyl can be installed using 3M 94 Primer and 3M Edge sealer, these are recommended by 3M vinyl wrap training class, these products will promote adhesion and add life to your vinyl. The sealer or primer will not remove the glue, deform the vinyl or ruin the texture unlike cheaper quality films.
• Made with an automotive-cast vinyl. Protects your paint from scratches and wear. Can be easily re-positioned and stretched for exact fitment and is soft enough to conform to all edges/contours/shapes. Creases and air bubbles can be removed by applying heat and using a squeegee.

Specifications:

Water resistant and weather proof.

Flexible and Stretchable for concave area.

Low cost to change the look of your vehicles.

Easy installation with dry application method.

Heat gun or household blow dryer for shaping is required.

Low - medium tack self adhesive .

Easy to fit in most tight spots or corners (3M primer 94 is required for non sticky surfaces, curves, corners)

Material has no warranty for fading. Fluorescent Neon colors tend to fade faster than normal colors. Fading can be reduced with over lamination, preventing stretched areas, which fade even faster, and shelter from high U.V. times during the day.

Material is specially made for vehicle exterior paint surface in good condition. Buyers take self responsibility on unsuccessful result on other usage.

Always pre-test vinyl installation on vehicles.

Due to different monitors/calibrations, colors may vary slightly from the pictures.

Film colors can vary slightly from roll to roll. For the most consistency, please purchase a full roll.

For best result, professional installation is required; Buyers take responsibility on physical damage during installation such as over heating, over stretching, ripping.

Package Content:

1 x Headlight Light Film Wrap